American access system ADV-1000 Guía de usuario descargar pdf (Pagina 397)

100

101

397

Debounce time can be set in the range of 2/60

- 15/60

of a second.

5 Shunt Time only comes into play when an event

[an interlock, or manual shunt] is applied to the

input point. Enter a value in the Shunt Time

field to set the amount of time that the input

point is deactivated (shunted) when triggered.

This can be set in seconds, minutes, or hours

using the selection buttons directly above the

option.

The field defaults to zero, but can be set from 0

to 63 seconds, 0 to 63 minutes, 0 to 63 hours.

Shunt Time cannot be applied to door status or

door inputs.

6 The Mode list offers three choices: Normal,

Latching, and Non-Latching. Latching is the

manual use of electronic access control creden-

tials in which one credential read causes a lock to

unlock and a second read locks the lock. The

lock changes state only after a credential is read.

Following is a description of each Mode.

Mode Descriptions

Normal

The input acts normally, reporting alarms, normals, and troubles.

Non-Latching

Entry: A door is set up as an input point, with an entry delay of 10 seconds. If the door

remains open more than 10 seconds, it is reported.

Exit: The exit delay is the amount of time a contact can be unshunted (unmasked) before

being reported. (Similar to a pulse time).

Latching

Entry: If a door [set up as an input point, with an entry delay of 10 seconds] is opened,

the user has 10 seconds to shunt the point, otherwise it will report as an alarm. Even if the

point returns to normal before the entry delay time runs out, if the point has not been

shunted (masked), it will report as an alarm.

Exit: The exit delay is the amount of time a contact can be unshunted (unmasked)before

being reported. (Similar to a pulse time).

Programming

1 2 ... 392 393 394 395 396 397 398 399 400 401 402 ... 776 777

Comentarios a estos manuales

Sin comentarios

American access system ADV-1000 Guía de usuario Pagina 397

Comentarios a estos manuales