American access system ADV-1000 Guía de usuario descargar pdf (Pagina 321)

100

101

321

2 Use the Time Zone drop-down list to attach a

time zone to each output point. For example, to

shunt [deactivate] an output point during a

particular time zone, select that time zone from

the list. The Time Zone defaults to None.

3 Enter a value in the Pulse Time field to set the

amount of time that the output point is ener-

gized when triggered. The field defaults to 0, but

can be set from 0 to 63 seconds, 0 to 63 minutes,

or 0 to 63 hours.

4 linking the changing state of the output point to

either another output point, an input point, or a

group of outputs. Refer to the following section,

"Enabling Interlocking for Outputs" for details

on setting up interlocking.

5 Create ADVs as needed for system control. For

example, the output ADV is used on the floor

plan definition to monitor the state of the output

point [Energized, De-energized, Trouble].

6 On returning to the Outputs window [after

creating an ADV for each output point], click the

Next button to advance to the Panel Configura-

tion - Groups window.

Enabling Interlocking for Outputs

1 Highlight an output point. Select the Interlock-

ing check box.

2 Select either the Input (I), Output (O), or Group

(G), radio button to indicate the point type with

which to interlock.

3 Choose the interlocking Point from drop-down

list.

NOTE: Only input points, output points or groups that

have already been activated appear on this list. If the

point you need is not listed, go to the correct dialog

and activate the point, then return to this window.

Programming

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 776 777

Comentarios a estos manuales

Sin comentarios

American access system ADV-1000 Guía de usuario Pagina 321

Comentarios a estos manuales