American access system ADV-1000 Guía de usuario descargar pdf (Pagina 264)

100

101

264 WIN-PAK User Guide

8 Select the Port to which the loop is connected.

NOTE: Select the TCP/IP port only for N-485-PCI with

ACK/NAK enabled. It is not recommended to use

TCP/IP for other devices that do not use an ACK/NAK

protocol.

9 Enter the Bits per Second communication rate

for the loop. For optimum performance the 485/

PCI should be set for 19200 (19.2 K). This baud

ratemust match the 485/PCI’s baud setting.The

Data Bits, Parity, and Stop Bits fields default

based on the loop and port.

IP Address

If TCP/IP Connection is selected as the Port, the

IPAddress or Node name field must be filled in.

Encryption Password

If TCP/IP Encrypted Connection is selected as

the Port, the Encryption Password field must be

filled in with the exact [case sensitive] password

used when the LAN hardware was installed.

10 Create an ADV for the communication loop.

Click Add in the ADV section of the window

(upper right corner) to open the ADV window

for the loop.Follow the procedures outlined in

“Setting upADVs” (earlier in this chapter) to set

up the loop ADV.

11 Click OK to return to the Port Settings window.

The Loop becomes available on the Device Map.

1 2 ... 259 260 261 262 263 264 265 266 267 268 269 ... 776 777

Comentarios a estos manuales

Sin comentarios

American access system ADV-1000 Guía de usuario Pagina 264

Comentarios a estos manuales