American access system ADV-1000 Guía de usuario descargar pdf (Pagina 34)

Speedway Reader IPJ-R1000 for Gen 2 UHF RFID

Upon receiving this command, the Speedway reader downloads the image file and, if the file is valid and eligible, performs the

upgrade. When this command is used, the upgrade will always be performed even if the version matches the current one.

If the upgrade is successful, the new image is not activated until the user reboots the system.

If the reader is in pull mode during the execution of this command, it is possible that the reader is currently retrieving the

metafile or performing an upgrade. In these instances, this command may return “Previous-Command-In-Progress”.

Note that this command does not change the reader’s upgrade configuration URI, but it sets the retrieve-mode to push, meaning

that the reader will not periodically retrieve upgrade configuration metafile until the retrieve-mode is set to pull again. See

section 7.4.2.4.

7.4.3. config logging Menu

The config logging commands provide configuration options for remote syslog capture as well as internal Impinj log capture

via sub-menus. Logging levels may be set to one of eight options (in decreasing order from most severe to least): emergency,

alert, critical, error, warning, notice, info, and debug. Which data are forwarded from the internal Impinj (internallog) log

capture to the remote system logging (syslog) depends on the relative level settings. For example, if the internallog is set to

the level of “critical”, and the syslog level is set to “debug”, then all internal log data will be sent to the remote system capture

because the severity level of the internal Impinj log data will always be greater than the remote system log. Conversely, if the

internallog is set to “info” and the syslog is set to “alert”, then only internal log data with severity level of “alert” and higher

will be forwarded. The internallog data is still accessible via Rshell but it will not be stored in the syslog. See Figure 7-2.

The commands are described below:

Commands:

Exit - Exit this submenu and return to the parent menu.

Help - Displays this help message.

. - Exit this submenu and return to the parent menu.

? - Displays this help message.

Sub-menus:

internallog - Submenu of internal logging specific commands.

syslog - Submenu of syslog specific commands.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 64 65

Sin comentarios

American access system ADV-1000 Guía de usuario Pagina 34